Though Android is the easiest, especially if you have an Android phone lying around unused, then install the Prismatic app and connect your phone to a USB dongle. The second is that LightPack does not work alone, you will need an Android device with USB, PC, Mac, Linux or Raspberry Pi connected to your TV.
#AMBIENT LIGHT TV TV#
The first is that you will have a setup on the back of your TV that looks like the spider like facehugger from the Aliens movies. Now, there’s still a bit of DIY (do-it-yourself) element to Lightpack.
LightPack provides an out of the box solution to your dynamic backlight needs. Method 3: LightPack If you don’t want to get your hands dirty in connecting wires and going through reams of research. Set the mood of your house, from warm oranges of a hearth to the cold blues and purples of a party night to romantic pink or yellow.
The best part about the system is that you control which colour your LEDs will show. If you have a slightly bigger budget, you can get better options with better remotes. Usually these things need direct infrared.
#AMBIENT LIGHT TV DRIVER#
The procedure is the same as Method 1, except you will need to position the driver in such a way that the remote control works with it. The whole shebang would cost you about Rs 300 for a metre, including driver and adapter. In addition to your adapter, you will also need to pick up a driver and a remote. You will have to pick up good quality RGB LED strips. Method 2: Budget with changing colours This is the same as above, but a bit more expensive. You have your very own backlight to show off. If there’s any overlap of LED, you can cover it up with the insulation tape too. You can also tape the adapter to the back, so you don’t have any visible wires. When you’ve finally stuck the light, you can use regular black insulation tape to tape over the exposed contacts if you reach around your TV to plug in stuff often. By putting it in a line, you get a dimmer light, but you get light distributed evenly around your TV. Remove the 3M tape and start sticking the LEDs in whatever way you want it to be around your TV. However, if you are doing the latter, make sure not to interchange the poles when you connect the wires into the socket. Now that you have your LED strips and connector, you can connect the + and - wires to a plug, or map them to a switch if you want. You can save some money if you have an adapter of your own and soldering skills. This is done by the electric shop themselves. Usually the LED will be cut at the connector nodes, but you will need a soldering iron to stick the adapter on to it. Once you get the wire, you have to purchase a 12V adapter with it. Note: Double check that the strip has a 3M tape on the other side. Usually it comes in singular colours, so you can get white light, warm white, yellow, red and other single colours. Whichever way you want it, just make sure you measure your TV first. If you want a slightly lower light radius, you can just put one-metre strip in a line, somewhere at the centre of the TV. They cost less than Rs 70 per metre, and a metre and a half would suffice for, let’s say, a 40-inch TV to go all round. Method 1: Budget The simplest method is to go out to the hardware shop and get LED strips. Here are four ways you can add ambient light to your life, for all types of budgets and all types of purposes. READ ALSO: 8 tips to save eyes from computer vision syndrome Having ambient light around your TV throws an even hue, allowing your eyes to remain focused without that strain.
0 kommentar(er)
